I resoldered the speaker wires only (and drilled a separate hole in the chassis for them so they wouldn't cross the board. Works normally now!
EDIT - and now back to where I was before after one...
Type: Posts; User: Crims
I resoldered the speaker wires only (and drilled a separate hole in the chassis for them so they wouldn't cross the board. Works normally now!
EDIT - and now back to where I was before after one...
I made sure it's a momentary. I can try resoldering if necessary.
Ok, I charged the battery fully which solved the swing sounds. It still won't turn off though.
I found one other person having this problem, didn't see a resolution on it. I also checked the...
Not sure on the first - this was a fresh out of the box battery from TCSS. The second is a yes, I have a resistor on it, I believe 1.8 ohms. I'm using an LED that once went to a US saber.
So, I wired a NBv2 with no recharge port or FoC, using page 9 of the manual. I hooked everything up and it will change soundfonts while off and start up no problem, but won't power down when I hold...
That's a relief, thanks! I really didn't like how an additional extension changed the aesthetic.
Hi,
I'm currently working on an easier build, but thinking about what I'd like to do as a personal saber later on.
This is the design I worked up in MHS builder:
12781
My only concern is...
Hey, that was it exactly! Thanks a bunch for your help! Now I just need to wire up the switch and do some cram-fu + greeblies.
Just to add, I bypassed the transistor on the negative and went straight from the board negative to LED negative and the light worked fine as far as blinking on and off, but it did have the issue...
Hi,
So this is my first project and I've really been thankful for all the help and wiring diagrams here.
I got a US stunt saber and have been working on adding one of the Hasbro soundboards to...
I'm actually using another LED, hence why the 6v. That's just the info I needed though! Using the same calculator you linked. Thanks!
Hi,
I'm modding a saber and adding an Obi Wan Bladebuilders soundboard. I picked up a Philmore momentary switch for it and I'm trying to figure out the forward voltage and current to plug into the...