Ok all lets try this out and see if i can wire it up lol
G/W Foc setup
Source voltage = 7.4
diode forward voltage = 6.58
diode forward current (mA) = 1200
Resistor = 1 ohm 1.4 Watt capable ...
Type: Posts; User: vvenom
Ok all lets try this out and see if i can wire it up lol
G/W Foc setup
Source voltage = 7.4
diode forward voltage = 6.58
diode forward current (mA) = 1200
Resistor = 1 ohm 1.4 Watt capable ...
Thanks so very much guys thats so much help:)
in regards to the resistor to overdrive the white got any ideas what i should use as im not used to resistors that much other than what i used on my...
Thanks so very much for this i was in need of this bad :)
I have a question im bulding a Graflex with CF5.10 and a Yoda Chassis and a Purple MHS CF5.10
The Graflex i was hopping to get a...
Thanks guys
Hi All
Just finished my first saber and added the pics please have a look and give your feedback :)
Thanks
Thanks for the feedback guys i found that my blade was not finished :( so i have added some blade wrap today and its about twice as bright and holds a very nice core effect.
The sound i have done...
Very clean
I like the touches of gold its simple and very clean
So far only really getting the wiring done and trying to jam it all in there
Also the sound seems to be a little low i look at the memory card and its set to 4 so full and the led seems to me not...
Hey all
Im going to be starting my first build today as all my items came today from TCSS :p
Any way just a bit of the idea for the saber, i want it to have a nice agressive look and feel but...
Hi all
Im in need of your help with my Petit Crouton wiring diagram :)
I have read the manual many times and looked at as many wiring diagrams and im 50% sure i have it correct
First ill...
Thanks heaps for that i totally missed it :)
But other than that im good?
Again thanks for the reply
Hey all i posted a wiring schematic of what i think i will need to do can i get you to have a look please
Its in the first post
Here is a very rough diagram of what i think will be correct after i fully Charge each battery
Can i get some feedback on this before i solder them up :)
Thanks heaps guys
5601
Lol Caine i didn't even notice that :roll:
just trying to find a wiring diagram now so i can test it before i connect it to my pc-u
Hi all i know this is here but i have searched and searched with no luck i have purchased some TrustFire Protected 3.7V 2400mAh 18650 but i want to make a 7.4v stick pack
i also have the 7.4V PCB...