Well no one had any ideas so I just started trying to randomly pry bits off!
It went a lot better than I expected. Taking some pliers to it I found that the red button and clamp arm do in fact...
Type: Posts; User: harmless_toast
Well no one had any ideas so I just started trying to randomly pry bits off!
It went a lot better than I expected. Taking some pliers to it I found that the red button and clamp arm do in fact...
While I wait for the resistors, I put together a new version of the diagram to try and better plan out where the wires will physically fit.
https://i.imgur.com/H0TTlzp.png
A minimal resistor, like the .47Ω .5w in the store? I was really hoping to avoid having to wait (or pay) for shipping yet again, but I guess it probably can't be avoided.
I think I'm about ready to start wiring up my first NBv4 build, but wanted to check in here first and see if anyone has any final advice or corrections for me.
NBv4
G/G/W Tri-Cree
3.7v protected...
Yeah I have a PCB on the battery pack, and probably one on whatever charger I'd be using too, but with so much extra space in this hilt, and for only an extra $2 a board, I'd definitely feel more...
Yeah I really doubt there's hardware available, or space inside for sound, but I thought I'd throw it out there in case anyone had managed it before.
As for the ID, I'm not sure if there's other...
I was wondering if anyone has any experience or information about converting the Master Replicas .45 scale lightsabers for light. (I assume there aren't any sound boards that can fit in them.)
...
Thanks for the replies everyone!
This is what I was hoping for. It seems like the NB should be fine getting the 3.7v from the charger, and that the only potential downside might be slower...
I was wondering if anyone has any experience using a Micro USB TP4056 Charging board in a lightsaber as a recharge port. Would I need to wire a separate kill switch, or could I just wire up the...
It's being powered by the 3 AAs connected to the stock Force FX soundcard. According to the conversion guide I'm following, you don't need resistors with this setup, and I thought white LEDs need...
I'm wiring up my second ever tri-Cree LED from TCSS, to convert a "Rey's" Force FX lightsaber following this guide. It's a B/B/W star and I'm wiring them all up in parallel so I didn't bother to...
I was thinking I could have it flash a range of colors on boot-up (and maybe also on clash) and then "stabilize" into one color when I activate the blade.
I'm going for a heavily damaged,...
For my next saber build I'm using a Prizm 5.1 for the first time, and am hoping to include a crystal chamber reveal lit by an RGB LED.
The Prizm's manual includes a section on wiring up an RGB...