Yayyyyyy!!!!!!!!!!!!
Type: Posts; User: Andrewrox96
Yayyyyyy!!!!!!!!!!!!
http://gyazo.com/dd1fe8f74c8698c9f5a3230dda5a17b7
so where the arrow is?
So I have to connect the Dynaohm before the positive wire goes to the switch and only on the positive wire, so it would be in series as opposed to the parallel in my diagram?
Could someone make me a schematic for the following;
4AA connector with male JST
Latching blue ring 16mm switch
DynaOhm 20MA variable resistor
1000 mah 4 wire buck plug
Cree LED with male jst...
Should I wire the variable resistor in line with the positive terminal for the latching led switch, or connected the the positive and negative wires?
Is the 16mm Latching blue switch compatible with handle #3?
Does this schematic seem right? I have a 4xAA battery connector, a 100mah buckplug, a cree led, and a latching blue ring switch. http://gyazo.com/419364578ea6bbd584b4479c5f3a50bc
Ok so with the jst female batter, the jst male on the led and the wiring needing to be on the switch with a resistor for the switch would you be able to help me figure out a wiring guide? Or should I...
Also is the latching switch I chose too long for the hilt? It seems very long and like the wires would not fit. Also do I need a bezel for the switch or is it a cosmetic upgrade?
I do not have a dimmer option, I am trying to go as simple as I can as I can always re-wire in the future, so go for a 4- wire puck? anything else I would need?
Ok so I will switch the inserts and get a clip and will switch to a latching switch? Anything else I am missing, I have a resistor for the switch led. Will I need extra wiring?
Hey there, I would like to know if these would all work together and be good to go.
Parts in my wishlist.
http://www.thecustomsabershop.com/ViewWishlist.aspx?WishlistId=42986
it will look...