Search:

I have been looking around and while I have no doubt the answer is here somewhere, I just can't find it.

What do people use in LED sabers if they don't have room for the normal size star? The...

That pololu board looks interesting and I might be able to fit it and hide a momentary switch but it is going to be tight...looks like I need to do some switch research and measuring.

Thanks...

Thanks everyone! So I need an on/off for power down and the 18650 is good by itself. Now to find a suitable latching switch for the MR board...

That's exactly what I was thinking but I did not realize that there would be no power-down sound.

I'll have to figure out a place for a switch then...

I have a Parks hilt with very limited room that I am going to be adding electronics to, namely a Yoda MR board and a blue Lux III, but with the internal diameter of the hilt there is very little room...

The plastic M&M Mini candy tubes (the ones in the checkout aisles of grocery stores) are perfect to fit US soundboards inside. You just need to cut off the wide dispenser end. They also fit the 2AA...

Thank you!

I have been googling and looking through the forums but I don't see much information on the Luxeon 3w driver V2 other than the two reviews.

I'm specifically interested in the ramp up/down that is...

There are also two Vaders:
...

I think I just have the noobie "my lightsaber must be as absolutely bright as it can be" bug. :D

After all the extra reading I'm going to just start with using the MR soundboard and see how that...

Ah ok. I saw one thread where someone mentioned using the pucks to drive the soundboard and nobody said anything so I thought it was ok, but now I see that everywhere else agrees with what you say. ...

Hello! I've been on FX-Sabers for almost two months but I have been reading these forums for a little longer, just haven't posted until recently. I have been reading and searching for the last two...

Just wait a few months and there wil be chinese copies available everywhere for $50 to $200.

Fabulous looking Saber!

I know you said the pommel is a brasscraft 2641 lavatory/sink handle but I was curious what it was made of? Is it something that could be powdercoated?