Can I build the saber so that the accent led is the crystal chamber with the NB?
I realize that would leave no accent led's on the hilt.
Type: Posts; User: mr fixit
Can I build the saber so that the accent led is the crystal chamber with the NB?
I realize that would leave no accent led's on the hilt.
So pulsing colors is out no matter what.
Out of curiosity what will the NBv4 not do on my list?
I want the blade bright enough to be seen in the daytime. I'm not concerned with having the brightest if that helps. I have no idea what runtimes are possible. Can it run for 30 minutes? Is that...
at this point I may not be able to answer that. I don't know what bells and whistles are available
Planning for a build and need to decide which sound card to get. I'm not as concerned about the sounds as I am about the lighting. Here are 2 lists, one of what I must have, and one of what I want....
Aside from the pleasure of simply owning a saber I suppose my first priority would be the hilt. I have a plan for a nice custom hilt with a backstory in the SW universe. Second, sound and a blade...
Would you advise against this then? Would it be better with a different combo of sound and LED's?
I was thinking of running a couple of 3.7v in parallel to extend the life span. Good idea or no?
But the NBv4 will work?
Concerning batteries, will going to a 7.4v help or hurt?
Excellent.
So a Neopixel blade is everycolor, or any color you want to program.
Going with the Neopixals, are there any other differences on the electronics of the build?
Thanks.
How do you control colors? Do you simply cycle through until you get what you want?
I'm planning a build, and think I want to use the Neo Pixel blade strips for lighting the blade. But, I don't fully understand how they work. I understand if I get a tri-cree for light that there...
Metal lathe. May buy an emitter, just depends on how industrious I feel. Was thinking for sure buying the electronics.
I would like to build a saber from scratch. My plan is to use my lathe to make a hilt. I need to know what ID tubing to start with. How large does the ID need to be to fit the batteries and...
And a question or clarification on how this part is used with a sink tube. Do I understand correctly that this blade holder slides inside the sink tube and is held by whatever means you use...
Thanks! I was looking under sing tube parts and found the 1.25" blade holder, this one isn't listed there.
Couldn't find a part in the store, is there an adapter for a blade holder to fit a 1.5 inch sink tube? How is that done?