Search:

Just make sure you keep the bungees away from your face. You can really get hurt if they snap anywhere near your face. Always wear safety glasses when doing things like that :)

Here is an EXCELLENT thread from candlepowerforums on how you can get two stuck parts apart without scratching the crap out of them :)
...

Does anyone on here have a couple pieces of diffuser foam they'd be willing to part with? I'm start to construct a few strings and can't find the foam anywhere.

I get almost the same current readings with Energizer E2 Lithiums (Primare Lithium Disposable) as I do with Sanyo Eneloops (NiMh LSD). The only thing I haven't tried yet is temp wiring up a battery...

Thanks :)

Yes, I saw everyone's advice about measuring the current at the diode itslef and not at the battery. My last question that I was asking about (where I listed the voltages and currents at the...

Is the swing sensor in the PC for sale on TCSS the same as the one used in the CF? I heard someone saying "ball bearings" were used in the PC while I heard someone else saying the CF uses an...

I was reading/breaking the connection where the positive terminal on the battery pack was. I really don't understand why its not pulling 2x the current if the voltage isnt dipping on the pack.
...

OK, maybe someone can explain this to me :(

Sooooooooo I slapped a meter on my VA Bane ('Resistorized Red' + 'Blue' on a DX RGB). I get 0.65 Amp with Sanyo Eneloops and 0.75 Amp with Energizer...

So I just write down the current it's using in it's current direct drive mode. Then when I would wire it to the board, I would wire both dies up to the same pad on the PC board in parallel and set...

I want purchase a Petit Crouton Sound Module from TCSS as soon as they come back into stock but I wanted to ask a question before I do.

I have an Ultrasabers Bane in Violet Amethyst. I'm not sure...

I have the obi wan board and I'm cutting most of the top of the board off where all of the LEDs hook up. I only have one trace that needs to be jump soldered (the board negative) so hopefully...

Does anyone know what the safe operating voltage for the 2010 hasbro dvd econo board is? I'm going to try running it with 3 NiMh. I hope that I don't wind up under-powering it...

I've heard so many times that NiMh are 1.2V. Maybe that's when they're under load or something in a flashlight or 80% charged or something like that. When my Sanyo Eneloops (LSD NiMh) come off the...

HAHAHAHHAHA I was working on one of the new Hasbro 2010 (DVD in the box) Obi Wan sound cards about a week ago. I had it all set up on my work bench running on 4 AA NiMh and I was like DAMN THIS...