Sorry to take up anyone's time, turns out, after soldering and re-soldering some connections, all was fine. Not sure how those connection impacted the motion sensing ability... Loving the NBV4
Type: Posts; User: Oleenick
Sorry to take up anyone's time, turns out, after soldering and re-soldering some connections, all was fine. Not sure how those connection impacted the motion sensing ability... Loving the NBV4
Hello TCSS Forum!
Today I was finishing off my build with the NBV4 and, after I had soldered everything up and fit it in a neat chassis, no motion sense.
I am nervous that I may have somehow...
Hello all!
After much revision from the advise of Tom and Seth, I'm here: http://www.thecustomsabershop.com/ViewWishlist.aspx?ViewCode=99335742-d5ac-4314-ad40-6f4b653936d7
I live in Australia,...
Thanks! I didn't realise that these were trustworthy specs as I thought there was strong variance but if this is what everyone uses, so will I.
Bump, Yeah I'll go for the deep red. Do you know what resistor is best for that?
Thanks!
I was originally thinking red but deep red seems better I think.
Do you know what Ohm resistor I would need for the red LED?
Thanks! I've added what you've suggested to the wishlist.
I do have my own stockpile of wires to use. The LED is RGB
What do you mean by harness the LED? I could be wrong but what I have seen...
Hello TCSS Forum!
Looks like its time for me to make my first build!
This is my part list: http://www.thecustomsabershop.com/ViewWishlist.aspx?ViewCode=99335742-d5ac-4314-ad40-6f4b653936d7
...
Thanks for the reply!
I think I'll get a 1" blade with a trans white finish, and then maybe use some cellophane if I think its not good enough.
I'd love to get a 1" heat sink but the Heat Sink...
Hello TCSS Forums!
I'm doing a 3D printed hilt lightsaber and have a few questions relating to that.
I am currently trying to decide on a blade, this is my current wishlist:...
Thanks for the replies, that's clarified a lot.
Would you by chance know the forward voltage of the Tri-Rebel? I was considering testing it once it arrived but I just wanted a first hand account....
Hello TCSS Community!
I'm relatively new here, with some electronics knowledge. I'd like to run the electronics I might be using past all you savvy people.
Here's my list so far:
...