So beautiful. I need to get on the forums more often.
Type: Posts; User: Firestorm1964
So beautiful. I need to get on the forums more often.
Gotta love those Jevaho Bone Shrouds.
So the mylar that you use is adhesive-backed?
I suppose this is something that would have to be bought wholesale, since mylar is so cheap...
I think I've found something that would work, but would...
*bows awkwardly* I'm sure I'm not the first
Long time no see!
After 20 or 30 tests and countless hours of research(including my high school chemistry teacher) I've made these conclusions;
Aluminum Oxide is our culprit here. Apparently,...
I've read/watched several tutorials using various solutions, such as muriatic acid(used to balance pH in pools), or RootKill, both of which are available at my place of work(Home Depot). Once I'm...
Right. I have read a little bit about it. I'd just want to plate copper, I think. As you said about copper, then nickel(or nickel, copper, nickel depending on tuts), I've seen much the same...
Has anyone ever tried electroplating rather than etching? Or even, etching a design then using the same stencil to plate a different material in it?
Seems doable, but I must admit I've never seen...
This is just a concept build, I wanted to make sure I could do something before finding proper material, and the piece was inexpensive. The walls are very thick and theres an 1/8 hole running through...
Agree with JediCarpet, I'm in love with this. Absolutely incredible. Props!
Hey all, Firestorm here,
I'm using a Quad Cree for my build, and it gets VERY hot. I decided that I felt that the V3 Heatsink did not make enough contact with the inside of the choke section to...
^^ This is what I meant. I know full well there's no legal backing behind it
Yeah, that bothered me for a while... I considered using a paperclip and epoxy to fill the hole, but it seemed like...
I'll let you know how it goes
Whoa whoa whoa, you lost me. I was hoping to be able to do the design in illustrator, but I'm not following with "scanning and tracing." If at all possible, I want to cut out possibility of human...
Hello all!
I've run into a bit of a snag in designing etches for my saber. Specifically, this piece;
...
Currently we have 2 inch double female, 3in. DF, 4in. DF, etc....I'd love to see 2 inch, 2.5 inch, 3 inch, 3.5 inch, etc.
So....half inch increments in extension sizes!
Very true, I only meant that I'd never seen a plug using this specific idea, with the DC brushless motor casings
Hello there saber fans! I came up with a blade plug idea, and unless I'm mistaken, it is the first of its kind! I used the motor casing for a small 12v DC brushless motor- The kind that opens and...