Search:

I went back and looked at the Spec sheet out of curiosity. In order for the DynaOhm to actually do currently regulation on an LED, you have to have 2.6V+the Vf of the LED in question. If its a 2.1Vf...

I am live in the Northern part of the Greater Seattle area. Small town off the sound called Edmonds. Its a Nice area.
For work, I get to make a lovely, daily, hour long commute down I-405 to...

You could always shy away from the sink tube and go with a piece of Aluminum tube from Online Metels... someone (sorry forgot who) posted a link to the correct size. I repost the link: ...

That's good Lemonade.

But they are right, I looked at the pics and from a mechaical standpoint, the sink tube designs do look too weak: though they look really nice (don't get me wrong, I am not...

Sorry don't post much.

The PC board in the control box was taken from any old add-on card that you might put in a PC motherboard back in the days when ISA slots were King. The "tab" part with teh...

That is quite excecllent!!
Nicely done

Thanks Tim,

I will.
Guess I was being a little paranoid and wanted to really make sure, since I had seen some back and forth on the forums regarding the input voltage for the board.

I am also...

Hello All,

thanks for all the responses.
Yes I did mistype the Voltage of my trustfires. I know they are 3.7V, but they tend to put out 4.2V. A side note, one seems dead, so either the charger...

I also agree with that. I was hoping for at least a small paper with descriptions on it for the different pads/inputs. Thanks to Eandori for what was said about Voltage inputs and the outputs on the...

Good pics.
Mathematically speaking, those are sine waves of varying amplitudes and periods. Flip them 90 degrees and plot them along an x-axis, and it looks more like what you are used to seeing on...

another place you might find this fuse or one like it would be at www.digi-key.com they sell this brand. They also have the microfuse fuseholders, you solder this in instaed of the fuse so you can...

To get the end cap to stay on, try this. Flatten out a couple of tines, one on either side (180 degrees apart). Drill small holes through the hilt tube and then into the tine. Now, I used the...

I used a Dremel with the light duty cutting wheel with no problem. If you go to Lowes or Home Depot, you do need to pay attention to the type of sink tube, they are made of brass, but some are 20g...