Search:

Type: Posts; User: Kyphotic_Jedi

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    1,096

    Prizm 3.5 4,5,6 fonts won't read

    Having some problems getting my prizm 3.5 to recognize fonts 4-6. I have experience with these boards and know how to add fonts properly. This is one I had been holding on to for a while but...
  2. Replies
    2
    Views
    1,274

    Switch settings are correct. I agree there is a...

    Switch settings are correct. I agree there is a ground but my two eyes can't find it. Not sure about the cost or if it's worth sending a 2.9 for repair. My friend assumed it was a loss when he sent...
  3. Replies
    2
    Views
    1,274

    PC 2.0 problem.

    Trying to work on a PC 2.0 that someone had previously attempted to install with no success. He stated that he could never get the sound and the led to work at the same time. It sat for a while (...
  4. Replies
    6
    Views
    2,120

    Yes FJK. I know this is not the greatest policy...

    Yes FJK. I know this is not the greatest policy and surely others should not follow in my footsteps, I just have had no issues in the past. I usually only use resistors on reds.

    As far as wiring...
  5. Replies
    6
    Views
    2,120

    Yes. Once. I used a rebel b/w/w with b and w in...

    Yes. Once. I used a rebel b/w/w with b and w in parallel, underdriving the blue to mach the white. I have not had any problems with it.
  6. Replies
    6
    Views
    2,120

    TCSS Tri-Cree burn out

    I purchased a RB/B/W tri-cree recently to go in the graflex 2.0 run by a NB 3.0. The install went well but after a week now my blue cree is toast. RB is still hanging in there as is the white flash....
Results 1 to 6 of 6