Did not get much response form the couple we sent out. Just sent out another so once I hear back on that one we will move forward. I think they are good to go though.
Printable View
Did not get much response form the couple we sent out. Just sent out another so once I hear back on that one we will move forward. I think they are good to go though.
Anyone the size and length of those headless screws on both sides of the hilt? In the 19th picture.
I'm just sitting here pissed off that the conversion kit was finally released...and it sold out day one before I was able to buy one for myself...
>_<
fml
We did a small batch to begin with as we did not get much response on the Prototypes we sent out. What we did get was positive but not enough that I was going to risk sending out 100+ bad ones. We will make more as soon as we get positive feedback or at least no negative feedback.
What can I use to bridge the 5 pads together?
And do you reuse the cross guard blades? If so do you have to cut them down or sand them?
solder..wire..etc..
You do nothing to the side blades as this kit only addresses the main blade.