Korbanth Brothers (Graflex 2.0 and K4)

Here are my new newly finished (for now) Korbanth sabers:
https://i.imgur.com/9SBIvVu.jpg

On the left, a K4 with the following configuration:
- NBv4
- 18650 10A battery
- Tri-Cree XPE2 B/B/W
- Transistor switches
- 20mm 3W speaker
- simple chassis from thingiverse: https://www.thingiverse.com/thing:2146816
- in-hilt recharge port, accessible by removing booster and pommel
- trans-white 7/8 blade with 2ft of giftwrap and shine-through tip

And on the right, the newest configuration of my Graflex 2.0 scratch-dent kit:
- NBv4
- 18650 10A battery
- dual skinny SK6812 strips
- Slytools clamp switch holder
- Railmaster 28mm speaker
- profezzorn chassis and blade adapters: https://www.thingiverse.com/thing:1691758
- in-hilt recharge port, behind the pommel cap
- TCSS smoked glass-eye thumbscrew
- Clear 7/8 blade with TCSS diffuser and 1/32 foam wrap
- ANH config, just waiting on another bubble strip to arrive to replace the circuit board

The K4 is shockingly loud, much more than the Graflex. Some of that has to do with speaker placement, as the Graflex chassis has the railmaster mounted near the clamp, rather than at the pommel, but that little 20mm packs a big punch. :D I'm also super-pleased with the LED in the K4, it has a very nice flare at the base that is so bright it's hard to look directly at it. The skinny neopixel strips are nice and bright across the blade but not as bright as that base flare on the K4.
https://i.imgur.com/tc4HItF.jpg
https://i.imgur.com/OGARhXd.jpg
https://i.imgur.com/GZLr9sE.jpg