Cf 8

Hey guys,

I wanna check if this is correct- I've successfully built this build before with the exception of the recharge port.

I want to check if I'm doing it correctly because after wiring it up -upon saber performing anything other than activation and deactivation my motor surges and the saber stops functioning.
I then replace the kill key in saber and remove it for successful boot and ignition


Specs-
CF 8
7.4 volt TCSS battery pack
RB,G,A tri cree led
recharge port
motor(can't recall voltage-currently working on another saber tho-same motor and set up)
2 accent led(currently-wanna add bar graph once this is sorted-I do have all the smd resistors soldered to board currently)
Attachment 14660
Attachment 14661
Attachment 14662
I included pictures of the connection to board from motor-Maybe my soldering for the motor lead is bad to the board
Anyone know any tests or suggestions for finding a solution?

I appreciate the help.

Specs on the motor will be important. It is probably pulling too much current. Do you have a resistor on it?

I have to go by radio shack to find out the specs-

No resistor on it-

Ive wired an exact motor match to a previous build(exact wiring schematic as well) where the only difference was I used a jst quick connect instead of a recharge port

Quote:

---

Originally Posted by Salohcin0083

I have to go by radio shack to find out the specs-

---

Sorry for the dealy(Darth Real Life)

The motor is a 3.5 v motor