Printable View
i finished my el saber today, it came out great, he only problem was that the poly c was slightly too large to fit in the blade holder, is this a common problem?
http://i18.photobucket.com/albums/b1...uy04/vader.jpghttp://i18.photobucket.com/albums/b1...ber3_small.jpghttp://i18.photobucket.com/albums/b1...uy04/dooku.jpghttp://i18.photobucket.com/albums/b1...04/sidious.jpg
How long have you held on that the holder? I know Tim had a problem with that when he got his shipment of PolyC a while ago. I remember it coming up with LEDs but I don't see why it couldn't have been a problem with EL too.
Sometimes it's off by a hair (.001" or something stupidly small).[:(]
<center>http://www.geocities.com/ghost_soldi...ner_trans2.gif
www.dewbackwing.com</center>
that must be it because i got the holder over a month or two ago and the polyc just came in today. it saddened me, but i filed the end of the polyc to make it fit, its all good.
http://i18.photobucket.com/albums/b1...uy04/vader.jpghttp://i18.photobucket.com/albums/b1...ber3_small.jpghttp://i18.photobucket.com/albums/b1...uy04/dooku.jpghttp://i18.photobucket.com/albums/b1...04/sidious.jpg
Yup, that'll do it. As long as it wasn't too much filing there shouldn't be a problem and Tim is aware that the PolyC he got a bit ago was slightly different.
<center>http://www.geocities.com/ghost_soldi...ner_trans2.gif
www.dewbackwing.com</center>
Yup.. The new polyc would not fit into the holders. I make sure I machine the holders if anyone orders blade materials along with them. Hard to tell who has the old holders though.
Tim
The Custom Saber Shop
Tim I noticed on the poly-c that I just received the the ends where slightly enlargered at the cut point, I had to sand down the ridge at the edge to make it fit the holder.
Do-Clo
Don't make me destroy you...
Yup..thats do to the manufacturer cutting them with some sort of pipe cutter instead of a saw. Next time I order I hope to avoid that.
Tim
The Custom Saber Shop