yes, It will actually be my first attempt at even makeing an Saber.
Printable View
yes, It will actually be my first attempt at even makeing an Saber.
Hey I too have a saber comming, and I just want to get it all strait before I order parts: I have the Mace Windu MR saber en route, so I need from this store:
-The Conversion Kit (Mace specific)
-The LED itself
-The Lense
-THe Lense holder
-NO complete blade?
-NO electronics kit??
Perhaps you see my confusion - I don't want to have to order things seperately, I want to get it all at once. Please help, thanks.
yes you will need the conversion kit +
led 3 watt
lenz holder
lenz
You can use the stock blade by sanding down the end a bit.
You are using the original electronics and sound from your Mace saber.
I beleive that is all you need, I will be getting my Vader conversion kit Mon.
Yup all correct... You can reuse the MR blade. Just about any blade is better, but you don't need another one.Quote:
Originally Posted by Wordsquirrel
No electronics kit either... the board of the MR will run it fine. Check out the tutorial here.
Ah, but here's the crux of the problem:
My saber comes w/ a "slightly used" blade, and I want a superior one that can handle bashing around. Which one do I got with from this site to minimize cost?
You can save a few bucks by getting the blade components and building it yourself but for the money, a complete blade is the way to go.
Also, it is typical for TCSS blades to need to be sanded a bit to fit in to MR blade holders, MR blades normally are loose in TCSS holders and some times even need a small bir of tape.