RE: MHSv1 Nano Biscotte V4 Assembly

I have three questions.....
1. Where do you wire a charge-port? I noticed what looks like a screw in the board for the + and -....solder to that?
2. Is there a place to wire an accessory LED for a lighted switch as in the standard NB? Is it in the same general location?
3. I appreciate the support for the 3rd LED for RGB. How does one change colors? Can it be done on the fly (like the Pico-Crumble)
or do you have to configure this on a computer?

Its a removable cell so you don't use a RCP. I suppose one could modify it and put in a static cell and do an RCP, but I wouldn't.

Not sure, I assume so.

You set the drive values in the configs on each font.

Thx....