Tri cree flicker configuration question

I just upgraded my stunt saber from a single red led to a red/red/white tri cree for flash on clash using a verso. The flash works great (though I think thee red could be brighter. I might have been overzealous in my choice of resistor). Anyway, I’m using the “unstable” font and there’s a flicker that (I think) varies the brightness of the red. But I’d like it if it tossed a little of the white in there for added instability.

Is this possible? If so could I ask someone’s advice? I don’t fully understand the manual on the subject.

Thanks guys.

Hey Alderscorn

Have you asked over on The Rebel Armory? Verso isn’t sold in the TCSS store, so there isn’t as much support on these forums for it. I’ve seen info & support for it on TRA or on FX-Sabers.

- Steve

Oh whoops, I hadn’t even thought of that, thank you.