Question about removable chassis

Printable View

10-03-2018, 08:52 AM
BrutalMaz

Question about removable chassis

So I’m trying to figure out how the sabers with removable chassis work? For example the activation switch, if the whole thing is removable how does the switch still operate? I get recharge port just stays built into the chassis but the switch part is confusing me lol.
10-03-2018, 12:59 PM
Silver Serpent

The outer sleeve of the saber typically has a plunger that presses the real button in the chassis.
10-04-2018, 09:07 AM
BrutalMaz

Quote:

Originally Posted by Silver Serpent

The outer sleeve of the saber typically has a plunger that presses the real button in the chassis.

See that’s what I thought but then my brain was like “maybe they have metal contacts and when the chassis slides into the place the contacts connect with the switch allowing it to work” lol I over analyze stuff sometimes
10-04-2018, 11:01 AM
k6gad

Quote:

Originally Posted by BrutalMaz

So I’m trying to figure out how the sabers with removable chassis work? For example the activation switch, if the whole thing is removable how does the switch still operate? I get recharge port just stays built into the chassis but the switch part is confusing me lol.

If you have room you can attach the switch with JST connectors and just unplug them and slide out the core chassis, I've done that a few times.
10-05-2018, 06:51 AM
djmehs

I've also seen a version where, for example, GCS has a new saber with a removable chassis. In that saber, the switches are recessed and part of the chassis. Then the outer part has a hole in it allowing you to press the button on the chassis through the hole. I believe it's one of his production sabers called "Vector"

ShtokyD also utilized some sort of plug on his chassis for his KAM lightsaber to make the switches able to be "unplugged" before removing the chassis. Should be able to find something if you Google "ShtokyD KAM"

Both solutions are beyond my capacity to produce anything similar, but it doesn't stop me from admiring them!
10-05-2018, 03:11 PM
Jediseth

I did this on my latest build. It’s very difficult especially if your using two switches. It was the hardest part of my build. If your just doing a soundboard say a Nano with only one switch I believe it’s a bit easier. One of the difficulties is not having your saber rotate out of alignment.
10-05-2018, 09:50 PM
k6gad

Could you use a disguised set screw for anti-rotation?
10-06-2018, 03:26 AM
Greenie

One switch is no easier than two switches. It makes no difference. If one lines up, they both line up. If there is a fixed point of alignment it cannot rotate.
10-07-2018, 07:36 AM
k6gad

Quote:

Originally Posted by Greenie

One switch is no easier than two switches. It makes no difference. If one lines up, they both line up. If there is a fixed point of alignment it cannot rotate.

Like a groove on the inner chassis with a screw to keep it aligned?
10-07-2018, 08:41 AM
Greenie

Quote:

Originally Posted by k6gad

Like a groove on the inner chassis with a screw to keep it aligned?

Exactly that. Or a groove in the inner hilt and a proud screw on the chassis.

http://forums.thecustomsabershop.com...l=1#post271592