Custom Darkwolf Sabers V3 Soundcard

https://www.facebook.com/CustomDarkW...type=3&theater

(V3 schematic above)

I have a Dark Wolf V3 soundcard and I'm trying to figure out how to get it to recharge. It works just fine without any issues, but the problem is that I can't get it to recharge. It is suppose to have a blinking red light when charging but it's not doing that at all.

The way he does it is by using a two prong recharge port, where as I have a three prong recharge port. I have pictures on how to use a three prong but I don't understand it. Perhaps only using a nano biscotte has confused me. So if anyone can offer suggestions on this that'd be awesome.

Also I have contacted the owner but he hasn't been able to help either so perhaps the fault lies with me not understanding something.

You would need to contact the manufacturer or builder of that card.

Based on what I see in the schematic, the positive pad on the board and the positive lead on your battery need to go to the same positive leg on the charge port. Then, the negative from the board and the negative from the battery go to separate legs. Look at the photo he has posted with the wiring diagram. Recharge port wiring is largely the same on every board I've ever seen as you basically just have to put the port in between the battery and board and there are only so many ways to do that.