I like the gun metal better then if it was painted black because it shows the look of different types of metals in just one piece. And your entire saber achieved its look without the use of any paint. Its looking very cool darth chasm.
Printable View
I like the gun metal better then if it was painted black because it shows the look of different types of metals in just one piece. And your entire saber achieved its look without the use of any paint. Its looking very cool darth chasm.
Very nice for sure. I think that gunmetal finish works for some reason though. Different and cool. I'd actually go for a red blade if it were up to me though :P I also like that pommel design
I design and 3D print them. But you could probably do something similar with the discs from TCSS and a little creativity, files and glue.
These were printed in metal. But I also discovered a way to plate plastic prints. The DCLS-004 build log shows that.
Thanks, I'm going to have to research that stuff.
Very nice design. Love the copper emitter, that had to be expensive! I looked into getting some large diameter brass and copper but I will have to wait until I get better at fabrication. How did you make the wire loop for your D-ring?
Thanks. It's pretty easy to do with the right tool. I have the one on the bottom.
Attachment 15102