Hasbro board / multi LED hook-up question....

Hey all...

Question, I used my voltmeter on my board (w/ out the blue LED) and it seems to be using only 1v (w/ 2 AAA hooked up, my voltmeter reads a 2, so if 2 out of 3 volts is getting through, I'm assuming only 1v is being used). I am hooking up a red Cree-XPE (2.6v @ 350mA) and a red super bright (2v @20mA) in series to the +/- of the original LED points on the board. I would like to use 4 AAA. So would I be correct to assume: 6v - (1v + 2v + 2.6v) = .4 So I would resist the board for that .4?? or do I need to resist the board and LED's separately??

Any help on wiring this thing up would be great.

Thanks in advance...

Stephen =]