Hi everyone,
i'm working on a 7/8 neopixel blade and was wondering if anyone had any tricks to getting the foam diffuser up in the blade. I can get it about halfway and then it just starts getting stuck.
Thanks
Printable View
Hi everyone,
i'm working on a 7/8 neopixel blade and was wondering if anyone had any tricks to getting the foam diffuser up in the blade. I can get it about halfway and then it just starts getting stuck.
Thanks
You could try pinching the section you are about to put in, then twist and push slightly.
Tie a string to the end and pull it through.. unless you've already got the tip glued in