QFT.. I always sand my heatsinks, not the blade holder
Printable View
I might have thought to try that, if I hadn't already put the LED onto the heat sink with the thermal tape, that stuff gets messed up easily if you try to move the LED after it's stuck down. :rolleyes:
You need to take off .055" approximately to make a full 360 turn of the blade holder.
All you need to do is figure out your approximate angle of "offness", divide that by 360 and then take that answer * .055" and you'll have a good idea of how much needs removed.
or you can sand it a little bit at a time :0