Whats the easiest way to wire up the Illumicore to the CFX?
Do i need a resistor for it?
Printable View
Whats the easiest way to wire up the Illumicore to the CFX?
Do i need a resistor for it?
For the Red, most likely. Blue and Green should be ok. How (or more importantly where) to wire it depends on what else you have going on in your hilt.
If you are talking about the pixel crystal, simply connect the power and data lines
Add a 330 ohm resistor for data.
Resistors are never "required" they are useful in some instances. I use bare pixels all the time without issue.
If using the Illumicore with the KR Pixelstick blade, which is preresistored, would you still need a resistor on the data line before the crystal? Or would it be ok since there would be one in the chain because of the pixelstick already having one? Greatly appreciate any insight, thanks.
That's really not how it works, the resistor, when needed, needs to be as close as possible to the first pixel in the chain. It is for signal integrity. You don't necessarily need it, but it is easier to just put it in and not worry about it then be done and have your pixels misbehave.