Printable View
Hello,
I've got a Crystal Focus 10 sound board and want to be able to use the color switching awesomeness.
I was hoping I could have someone verify that I am getting the right stuff.
LED
battery
heatsink
Red: 1.2 Watt capable or greater 1.2 ohm resistor
Green: 2W or greater 1 ohm resistor
Blue: 2W or greater 1 ohm resistor
This is going in the DV6 hilt kit.
I used the this calculator to figure out what resistors to get.
Thanks
Yo don’t need the 15A discharge for those. The standard 4A discharge battery will be fine for an in hilt LED. You can also use the RGrB for the LED. You also need a speaker.
Good to know about the battery, thanks. I forgot to list it but I picked a premium speaker and the base speaker, still trying to figure out which one I like better.
Forgive my ignorance but is RGrB for red, green, royal blue? Is there any advantage to it in your experience?
Yes, that’s what it means. It allows you to make all of the visible colors. So yeah, I (and everyone else) consider that an advantage, especially if you want to change colors.
Awesome! Thank you so much.
Are you doing a hard wired battery? If so, you need a recharge port. Assume you got the momentary switches with the kit? Obviously need a chassis to hold everything...there are lots of options there. You need a lens for the led star, and tape or heat resistant glue to attach the led to the heat sink.