-
polyc to large?
-
How long have you held on that the holder? I know Tim had a problem with that when he got his shipment of PolyC a while ago. I remember it coming up with LEDs but I don't see why it couldn't have been a problem with EL too.
Sometimes it's off by a hair (.001" or something stupidly small).[:(]
<center>http://www.geocities.com/ghost_soldi...ner_trans2.gif
www.dewbackwing.com</center>
-
-
Yup, that'll do it. As long as it wasn't too much filing there shouldn't be a problem and Tim is aware that the PolyC he got a bit ago was slightly different.
<center>http://www.geocities.com/ghost_soldi...ner_trans2.gif
www.dewbackwing.com</center>
-
Yup.. The new polyc would not fit into the holders. I make sure I machine the holders if anyone orders blade materials along with them. Hard to tell who has the old holders though.
Tim
The Custom Saber Shop
-
Tim I noticed on the poly-c that I just received the the ends where slightly enlargered at the cut point, I had to sand down the ridge at the edge to make it fit the holder.
Do-Clo
Don't make me destroy you...
-
Yup..thats do to the manufacturer cutting them with some sort of pipe cutter instead of a saw. Next time I order I hope to avoid that.
Tim
The Custom Saber Shop