-
http://www.thecustomsabershop.com/2A...lder-P348.aspx
The description makes it sound like they fit. I was going to heatshrink the whole speaker holder with the battery housing and sound board. Not sure if the protection circuit would fit in there too or not. I figured I may have to move that further up the hilt. It is hard to imagine all this without parts in front you and no experience. That is for sure.
-
My bad. Those ones will fit. I was thinking of 17500's.
Definitely heatshrink, though I'm not sure on the outside clearance of the holder.
You might want to make sure it will fit in the hilt after heatshrinking.
Otherwise, it's not terribly difficult to just heatshrink the batteries by themselves.
The only reason I can imagine you would need the battery holder, is to avoid soldering directly to the batteries,
which contrary to n00b belief, isn't terribly difficult with a decent iron.