How do I get it to fit if it’s female on both sides, also w/ the buttons taking up half the hilt diameter do I just need to be extra careful with planning where my wires go around it?
Printable View
How do I get it to fit if it’s female on both sides, also w/ the buttons taking up half the hilt diameter do I just need to be extra careful with planning where my wires go around it?
For a normal HP LED setup, there should be enough clearance around the AV switches in the hilt to get to the emitter. and the shop has adapters, either a double male or gender changer, look under Adapters in the MHSv1 section.
Just an FYI, that LED module is not correct, it is for 1-in diameter tubes...not MHS parts.
You need this one: https://www.thecustomsabershop.com/M...ink--P841.aspx