Ok, so the title about says it all. I am getting ready to wire up my first NBV3 with FOC. I have wired plenty of V2 but never with FOC.
My question is, do I just use the same resistor on the FOC LED as I would if it were the main blade? For example, I am using white as my FOC. If I were using it as my main blade, I would put a 1ohm 2w resistor on it. Would I use this same resistor for the white being used as FOC or does the FOC require a different resistor? I know this does not need a PEX board but I never used a PEX board before either so I have no basis for comparison to build off of.
In a nut shell: does anything change in the resistor calculation for the FOC LED?
Thank for any help you guys and gals can offer.
