-
Recharge port to deep?!
Ok, I'm not sure how I went wrong, but after months of slowly building a saber for a friend I was finally ready to plug in and give it a final charge before calling it done.
Buuuuuut, the recharge port is to deep for the plug to reach!!
I have the recharge port mounted on the Acrylic Chassis Disc for Recharge Port inside of a MHS Gear and I'm using one of the longer kill key pieces for it.
Does anyone have a solution for this? Is there an adaport I can get that will have a longer 2.1mm barrel plug?
Much Thanks,
The Yin
-
Ok, answering my own question. I just used a razor blade and cut back some of the plastic so the plug can fit.
Still, feel free to mention what methods or suggestions you guys have to address this issue.
-
You could make the hole in the hilt bigger so that the moulded plastic of the 2.1mm plug fits