MR FX sound modules schematics and discussions
http://www.thecustomsabershop.com/sa...oundwiring.jpg
2005 MR Luke
Should be ran off of 4.5-6v. You do not need to use the LED output of the board. If you do use the output the LED may be ran at too high or too low of amperage.
Tim
The Custom Saber Shop
3 Attachment(s)
How to adapt this soundboard?
Here I post some pictures of a soundboard from a 2003 FX Luke's ROTJ saber by Master Replicas (EL blade). I bought it from one of my friends recently to use it in an MHS Luxeon 3 LED saber that I'm working on.
It differs from the 2005 model in some details and there are few things that I'm not very sure about and really could use some advice... (even though it seems similar to what you have been going over in case of that Mace Windu soundboard)
-First thing is the battery/speaker wiring (picture 2 and 3), those transposed cables on the battery counterpart and speaker cross-wired to the original battery holder flustered me a little, would it be ok to re-wire it separately (for stand-alone battery packs)? The red and brown cable (pic. 2) is for the battery, orange and yellow one for the speaker... am I right?
-The second thing is the switch- what about these four cables? How to wire them to an SPST Latching Guarded switch that I originally bought for my saber?