I may be using a 8/32 to hold on a piece of wood near the emitter and it may go through the threads... I will know better once I finish the wooden addition.
Printable View
I may be using a 8/32 to hold on a piece of wood near the emitter and it may go through the threads... I will know better once I finish the wooden addition.
Don't know if you still need this, but there are videos on YouTube that cover "safe" etching. I say "safe" because it looks fairly safe, but I'm no expert and have not had the chance to try this myslef. DO AT YOUR OWN RISK.
Can be done with water that is highly saturate with salt(non-iodized) and a 9V battery.
https://youtu.be/bV-PItEcLXY
and a slightly different method shown here:
https://www.youtube.com/playlist?lis...HvVqG-5nnITUaL
I would not dump the entire piece in like the second link will show, but I would take note of how to make a stencil for your design then follow what the person in the first link shows.
I also would like a video on making a Crystal Chamber using parts from TCSS. The main thing I would like though is a video on the NB v2 MWS Header and Wiring Harness from the store. I am planning on getting one when I order my NB and I haven't found a tutorial on it.
The Crystal Chamber video was done. The wiring harness is kinda self explanatory, using the diagram in the manual, you can easily figure out which JST connector goes where. (LED, battery, switch, speaker)
Are there any videos or tutorials on adding/incorperating accent LEDs to a build?
There could always be more crystal chamber videos. Tons of ways to skin that cat.
A video for folks wanting to work with aluminum black for weathering would be cool.
How about a video comparing the features of the various sound cards?