Help with adding a Latching Led and BCD to a 616 Board.
Hi ALL
I have done a very rough schematic outlining how I was thinking I could add and extra AV led Switch and Binary Coded Switch to a joe jedi board. I have looked at the other schematics and work done on the boards and think I have it right.
Would love those who would know to tell me if this will work.
Oh and as an afterthought will I need to add a resistor to the Red + to get purple from the binary switch?
Here is the schematic
http://i951.photobucket.com/albums/a.../Schematic.jpg
Just so you know what is going on between the led and the BCD Switch. I was under the impression that all the wires (except the yellow for the motion sensor) went to one of the solder plates and then the brown went from that same plate to the negatives on the LED in relay. The Red, Blue and Green on the BCD then are wired to the positive Red Blue and Greeen on the LED