Removable Blade wiring help
I am currently attempting a luxeon conversion on my removable blade anakin. Most of the steps are the same as the fixed blade version but I hit a little snag with the wiring.
Here are two pics of the base of the blade.
http://i51.photobucket.com/albums/f3...r/DSC02762.jpg
http://i51.photobucket.com/albums/f3...r/DSC02764.jpg
There wires are labeled this way on the pcb.
1- brown
2- red
3- orange
4- yellow
5- green
6- blue
Ground- Grey
Impact- white
I figure out 1 to 6 are the negative wires so does that make the ground wire positive?
Also, I know one wire is supposed to go to the clash sensor but where is the other wire from the clash sensor to the led? I couldn't figure out where it it is for the life of me.
This is the last step I need to figure out before I proceed to wire everything up. Thanks.