Printable View
Currently we sell it in a 11.75" section but I would rather sell it in shorter sections and make it easier to fit on the shelf and lower the per piece price. I am thinking closer to around 8.75" and wanted to know if any of you who have used the parts think that would be too short.
That length would be just fine for me. I tend to cut the threaded rod up when I get it.
I also cut them shorter works for me
I can see the tubing, because you want sections in between the discs, but I have actually used the threaded rod close to its full length. My last build ran threaded rod from the BH to the speaker in the pommel. Although I think 8.75 would be plenty for this, some people prefer longer hilts and would either suffer or be forced to shop elsewhere.
For me, that is to short. I like the long sections and don't often use less than 8.5"
I would prefer it long, but my world won't end if you decide to sell it shorter. It's not like it's a specialty part that we could never replace; and it's an internal piece at that, so if I should have to cobble a Franken-chassis together with short pieces and toothpicks, the aesthetics won't be upset too much by it.
I cut my rods up quite a bit but if I had it to do over then I would have used two 8" sections. (a wee bit over 8")
That's in a saber hilt 12.75" long
When I get some extra money I'll probably do just that. 8.75 is fine by me with the caveat that this is my one and only saber.
I will just leave them at 11.75" thanks for the feedback guys.