Seeking help and opinions on Kylo ren build
Modifying a Kylo ren fx black series. Will be doing both body and electric work to it. Never built (I guess I'm not really building this one, just changing it) a saber before but am confident I can make it happen. Here's my list of desired parts.
TCSS
Crystal focus v8
2x PC/cf color extender
7.4v 2600mA Li ion pack 18650 (not sure wether I should have a lower current)
Kylo conversion kit
Stainless steel momentary switch AV or SPST momentary switch for main blade
SPST momentary switches for extra sounds
RICE port
Switchcraft 2.1 mm Power Jack
2W 28mm speaker
3x 1" heatsinks with center holes
Associated wiring and resistors
3x Tri Cree r/r/w
3x lenses
(My first idea was to use r/g/b/w LZ-4s but not sure I can make it work)
I'm unsure of myself as far as my calculations for resistors go. I was thinking I would probably run the side LEDs in parallel but I'm not sure I'm putting in the correct values to the led calculator. Spec sheet says the red is 2.2v, green is 3.35v, blue and white are 3.2v, all having a forward current of 700mA. With this information I have gotten these calculations
Red
Led calculator - 4.7ohm/2.303W
(7.4-4.4)/.7=2.1ohm
7.4*.7=5.18W
Green
Led calculator - 1.2ohm/0.588W
(7.4-6.7)/.7=1ohm
Blue & white
Led calculator - 1.5ohm/0.735W
(7.4-6.4)/.7=1.43ohm
The calculator says the green setup is ok but it's not likin the red white and blue.
Thanks for your time. All opinions, ideas, advice or criticisms are appreciated and welcomed. I realize this is a difficult hobby with a harsh learning curve but I'm trying hard to learn.
Thanks again.