Putting a Windu Soundboard into custom hilt
Hey everyone,
since the store is all out of NB Boards at the moment I am planning on taking the electronics out of my Mace Windu and install them in one of my other hilts to add sound.
I know there are tutorial for taking apart the Windu etc,
but what do I have to look out for?
I wanted to use the battery holder and speaker section as well, so I wire the LED onto it all like in the tutorials, but what then?
If someone could write up some sentences, that would be great...
- Can I use any (latching)switch?
- Do I need a resistor (In the conversion tutorials it works without one)?
Since all the tutorials are for conversions they all retain the original housing and switch...
Is there any kind of tutorial for what I'm planning?
Any help appreciated! :)
Sorry again for taking up your time to help me out.