Tab Content
  • scott's Avatar
    05-10-2019, 07:58 PM
    scott replied to a thread New builder in Parts lists
    I recommend watching Madcows YouTube videos on TCSS and Genesis Custom channels. East Coast Sabers how to build a Graflex will be very useful wether...
    4 replies | 193 view(s)
  • scott's Avatar
    05-08-2019, 07:31 PM
    scott replied to a thread OWK Kit Build in Gallery
    Thanks for the refresher...I actually followed Madcows advice and ordered tons of the low cost supplies (resistors, screws, switches, etc.) and used...
    9 replies | 678 view(s)
  • scott's Avatar
    05-07-2019, 06:23 PM
    No offense, but for being outside of the hilt, those wires are a mess. I can’t tell where your activation negative is going...should be to the board...
    7 replies | 304 view(s)
  • scott's Avatar
    05-07-2019, 06:18 PM
    Posted on your other thread, but your challenges are common. Again, not sure about the goth chassis, but look at the pics on the other thread. My...
    1 replies | 93 view(s)
  • scott's Avatar
    05-07-2019, 06:15 PM
    I had the exact same problem and bothered Tom T with troubleshooting...switched to 15a 3.7v and all was well...for sure can’t use the standard 5a...
    18 replies | 2199 view(s)
  • scott's Avatar
    05-07-2019, 06:11 PM
    scott replied to a thread OWK Kit Build in Gallery
    There are 2 switches in mine. The stock switch that comes with the kit fits right in the slot under the red button. I did glue the switch into the...
    9 replies | 678 view(s)
No More Results
About scott

Basic Information

About scott


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Yesterday 11:18 AM
Join Date

1 Friend

  1. jackHarry  jackHarry is offline


Showing Friends 1 to 1 of 1