Tab Content
  • k6gad's Avatar
    05-18-2019, 10:11 PM
    k6gad replied to a thread Jediseth build 13 in Gallery
    Seth.... saw this on FB.... these pics are much better... Awesome build! Love your CC detail...
    6 replies | 103 view(s)
  • k6gad's Avatar
    05-13-2019, 08:03 AM
    Wicked looking Saber! Love it!
    5 replies | 184 view(s)
  • k6gad's Avatar
    05-11-2019, 09:34 PM
    k6gad started a thread MHS V2 build in Gallery
    Just finished this MHS V2 saber... 8.5 long with shroud, NB4 all in one, cree RGB led, TCSS 3.7V 3150 LI-ION, milled the switch cover, self etch...
    2 replies | 127 view(s)
  • k6gad's Avatar
    04-29-2019, 01:07 PM
    Did you see this on the store site The pinout is different.. From top to bottom, board pinout ** Positive (+) ** Negative (-) ** Activator...
    2 replies | 243 view(s)
  • k6gad's Avatar
    04-24-2019, 04:54 AM
    k6gad replied to a thread NB V4 All in one in Nano Biscotte
    Ok ...thanks.. I understand that from the NB manual. Have not done that yet. Once the colors are associated with a font, when switching to that font...
    2 replies | 167 view(s)
  • k6gad's Avatar
    04-23-2019, 10:07 AM
    k6gad started a thread NB V4 All in one in Nano Biscotte
    This is my first go around with this all in one set-up. This is a pic of my wiring so far. Does it matter which LED in a Cree XP-E2 RGB is wired to...
    2 replies | 167 view(s)
  • k6gad's Avatar
    04-21-2019, 08:48 PM
    k6gad replied to a thread MHS build in Gallery
    Yes switches bezel was cut down to .49?” And then counter-sunk with a 0.50” flat end milling bit. I can lathe the covertech wheel myself and can...
    3 replies | 542 view(s)
  • k6gad's Avatar
    04-21-2019, 07:37 AM
    k6gad started a thread MHS build in Gallery
    Finished this MHS build. Cree XP-E2 RGB, Prizm 5.5. Handle space is tight so I had to bore it out and lathe down the V6 chassis I used, got it all...
    3 replies | 542 view(s)
No More Results
About k6gad

Basic Information

About k6gad
I am a have been a General Dentist for 30 years! Yikes. I have too many hobies..LOL. Picked up wood and metal lathe work a few years ago, also us a mill. I learn something every day....
Zip Code:
Wood and Machine lathe, motorcycling, Etc, Etc


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
05-18-2019 10:16 PM
Join Date