RavenXp

if you can source it sure, that 'closest resistor' part is just to guide you to the closest value the store carries is all, though some resistance...

it's typical practice to put a resistor on each die (color). Sharing a resistor you would likely suffer from either diminished brightness or even a...

the resistors needed for the LEDs can go on the negative lines. Doesn't really matter too much if the resistor is before or after the LED in the...

Should be doable, would need a PEx for the 3rd channel, a tri-cree lens, and the appropriate resistors for the LEDs. NBv4 is a dated board at this...