okay, I just took the one with the orange blade apart and... It has the board that was fried so now it is wired all funky, but I did figure what to bridge. on the under side of the color selector switch there are 2 row of 3 leads and to the right(with the led pointed away from you) there are two lonely leads. those are the red leads and the middle of the set of three is the green lead. just solder a wire from the middle one to one of the red ones. keep it in the same row(if going from the bottom row, use the bottom red. if you do it right you will still have 2 color options and both sound banks when you switch the switch. You can test it while it it on without soldering by just touching the wire to the points to fin d the. good luck, sorry I couldn't get you a pic, the purple bladed saber has a crappy switch from radio shack and I can't get the innards out without having to resolder the switch afterwords.good luck
