DM, techincal question... I am creating a PVC Force Unleashed Saber, in the picture it shows the anti Vandal switch in the upper portion of the hilt. I have built the hilt but due to the size of the Vandal switch am concerned about the fit due to the blade and LED locations... I know I will have to use a box to bring the switch up some from the PVC, but as you know things get tight in there. I am thinking a ribbon cable and moly connectors. The ribbon cable could be flattened and hot glued down, but I am afraid it wont hold down even if the LED is aft of the switch a little bit... I was also thinking of a smaller wire than ribbon. I am almost willing to try building a sled at this point so I only have to worry about two wires to hold in plce up forward... What are your thoughts on forward switch placement? Thanks Jarrod
That's cool, thanks.
It gives a flicker and sound effect if left alone, and then I think it does shut down, but I will double check and let you know for sure.
Jr, nice saber. I really like the sound. Does the saber shut off automaticly after 20 seconds or so like the previeous force action sabers?
pics and MP4 are up of my new saber!