Welcome fellow Tennessean. I am in Nashville. Nice to have someone near. Enjoy the support we get and give here.
I already have to projects going on at the same time, and I can't keep working on them until certain machine parts arrive or until LEDs arrive. Should I start a third time consuming project for the love of projects?
Hi all I've built a few sabers with no problems, until now ! I've built a Luke ROTJ bottom half master replicas, top half custom build, thin neck. I tested with a three aaa battery pack, Luke board, 3w green led, No problems. I then changed the power to a 4.8 four AA nmh pack And after a few minutes the led flickers. When I put the lower power Pack in its fine. Is it a led heatsink problem ? I'll try and upload pics of my sabers when I work out ...
http://www.thecustomsabershop.com/74...Pack-P699.aspx I was looking through the forums and found that when using the PC sound card the voltage has to be btwn 5.5 and 11v, thats the way I saw it. I'm not sure if I have it all right. also I don't know what wire i need to connect the Seoul P4, switch and charge port all to the battery pack. another thing im gonna be using the constant current driver (i have the 1500 in my wishlist but which would be best for a nice rich ...
If I wired the switch LED+ to the recharge port whould that work as well? Would just need a higher ohm resistor about 220?