Wiring diagram for a Vader ESB MRFx board with illuminated switch

[Dakarn]

Ok I made the following diagram based a bunch of posts I've reviewed over the past day or so and wanted to check if I am correct or if there are issues with it.

http://i113.photobucket.com/albums/n234/coasterg/Consilium%20Laurus%20Lightsaber%20Build/VaderDiag.jpg

[FenderBender]

I usually take both + and - leads for the switch LED off of the main board outputs but I don't really see anything wrong with the way you have it.

[Sidd]

Do you need to use a resistor for the switch LED and what kind?

[Dakarn]

I usually take both + and - leads for the switch LED off of the main board outputs but I don't really see anything wrong with the way you have it.

That is easier, I'll change up the diagram. Got my Vader board in today and since the illuminated switch is on the way to the LED that will neaten things up.


Do you need to use a resistor for the switch LED and what kind?

Yes, for the ones that Tim sells (and most of the ones I've seen that'll fit) you need a 220ohm 1/4w resistor. Check the resistor chart in the store for your specific LED.