Ovlos
10-22-2009, 10:16 PM
Fairly new here, been reading quite a bit. I just put together my wishlist, if I missed some key component please let me know. I'm aiming to have a red blade, and the best option that I could see was the White Seoul P4 with a lens, but if there's a better option out there I didn't see it. Then again these forums are big. *Shrug* Sound isn't a priority at the moment.
Electronics:
Optics:
Seoul P4 LED (White)
Luxeon Collimator Lens 5 deg viewing angle
Luxeon III/V Lens Holder
12 Colored Discs
Power:
BuckPuck 1000mA 4-wire
4AAA battery holder
SPST Latching Guarded switch with red button (Standard On/Off)
DPDT Latching red illuminated switch (Master Kill to be mounted in pommel, knowing me I'll leave it on at some point lol)
220ohm 1/4w resistor (for the kill switch)
Hilt / Blade:
Screw on LED blade holder style 8
MHS choke style 1
Hilt style 3 with guarded style switch hole
MPS Pommel style 7
MPS Insert style 2 (with Clip)
LED "TCSS style" Battle blade 1" OD (36 inches)
8-32 x 13/32" Black Thumb Screw (Quantity 3, Blade screws)
6-32 socket Head Cap Screw (Quantity 12, I'm planning on adding an over piece using sink pipe...maybe)
Covertec Clip
Oh...the kill switch is going to be wired in series with the main On/Off switch, does anyone know if the resistor will cause issues for the Buckpack? Thanks for taking the time to look over a nubbin's wee little plan :)
Electronics:
Optics:
Seoul P4 LED (White)
Luxeon Collimator Lens 5 deg viewing angle
Luxeon III/V Lens Holder
12 Colored Discs
Power:
BuckPuck 1000mA 4-wire
4AAA battery holder
SPST Latching Guarded switch with red button (Standard On/Off)
DPDT Latching red illuminated switch (Master Kill to be mounted in pommel, knowing me I'll leave it on at some point lol)
220ohm 1/4w resistor (for the kill switch)
Hilt / Blade:
Screw on LED blade holder style 8
MHS choke style 1
Hilt style 3 with guarded style switch hole
MPS Pommel style 7
MPS Insert style 2 (with Clip)
LED "TCSS style" Battle blade 1" OD (36 inches)
8-32 x 13/32" Black Thumb Screw (Quantity 3, Blade screws)
6-32 socket Head Cap Screw (Quantity 12, I'm planning on adding an over piece using sink pipe...maybe)
Covertec Clip
Oh...the kill switch is going to be wired in series with the main On/Off switch, does anyone know if the resistor will cause issues for the Buckpack? Thanks for taking the time to look over a nubbin's wee little plan :)