Onli-Won Kanomi
09-03-2009, 12:38 AM
If one wanted to have dual holes pre-drilled for two switches mounted one behind another on a MHS hilt or df section how close together can the holes be drilled? I'm guessing there needs to be a certain minimum amount of distance between them for structural integrity but how much?
Also with the guarded switches and antivandal switches that have a nut on the inside that might be a factor?
And maybe the AV switch bezels might need to be mounted a certain distance apart too?
What I'm basicly trying to figure out is how much space it takes to mount two matched switches as closely together as practical without actually touching - of the regular [with 2 silver TCSS nuts], guarded, and AV [with 2 TCSS bezels] kinds.
Also with the guarded switches and antivandal switches that have a nut on the inside that might be a factor?
And maybe the AV switch bezels might need to be mounted a certain distance apart too?
What I'm basicly trying to figure out is how much space it takes to mount two matched switches as closely together as practical without actually touching - of the regular [with 2 silver TCSS nuts], guarded, and AV [with 2 TCSS bezels] kinds.