DarthHideous
07-25-2009, 08:10 PM
I just finished my next saber but still need to drill/tap for the blade set screw.
I have a #1 Blade Holder and wanted to know where the best location would be for the set screw. In the 0.25" thickest section, or the forward, 0.125" thinnest part? Also, is the blade more stable the higher up (toward the tip) the set screw?
My first thought was the thickest part because I thought the stresses of dueling would be too much for the thinnest section. I was looking around for examples of the blade holder, but there are not a lot of them used that I could find.
Thanks Guys.
BTW. Is everyone ready for Dragon*Con '09 ?
I have a #1 Blade Holder and wanted to know where the best location would be for the set screw. In the 0.25" thickest section, or the forward, 0.125" thinnest part? Also, is the blade more stable the higher up (toward the tip) the set screw?
My first thought was the thickest part because I thought the stresses of dueling would be too much for the thinnest section. I was looking around for examples of the blade holder, but there are not a lot of them used that I could find.
Thanks Guys.
BTW. Is everyone ready for Dragon*Con '09 ?