View Full Version : MR/Hasbro FX Wiring Diagrams
Lord Maul
07-17-2009, 10:54 AM
This will be run like the cheapy Hasbro thread. PM me with submissions. This thread won't get as full, as there are only so many boards.
Credit goes to Tim.
http://www.thecustomsabershop.com/sabers/scripts/lukesoundwiring.jpg
2005 MR Luke
Should be ran off of 4.5-6v. You do not need to use the LED output of the board. If you do use the output the LED may be ran at too high or too low of amperage.
Lord Maul
07-17-2009, 10:55 AM
Credit goes to Matakin.
http://i140.photobucket.com/albums/r4/mattkym/FX_Sound-board_diagram.jpg
Lord Maul
08-06-2009, 10:13 AM
Thank you Jay Gon for these latest diagrams
Here's a diagram for a 2007 Yoda FX soundboard:
http://i119.photobucket.com/albums/o141/Jay-gon_Jinn/MR%20Sound%20Board%20Pictures/101_5205-1.jpg
http://i119.photobucket.com/albums/o141/Jay-gon_Jinn/MR%20Sound%20Board%20Pictures/101_5206.jpg
Here it is with the clash sensor attached....if possible, solder the clash directly to the board on the bottom of the header for the blade connector. It'll make it much easier to install.
Here's a diagram for a Vader/Maul/Anakin ROTS/Obi-wan ROTS/Luke aNH:
http://i119.photobucket.com/albums/o141/Jay-gon_Jinn/MR%20Sound%20Board%20Pictures/21ccc4b8-1.jpg
Pic of a Luke ANH/Obi-wan ROTS w/better wiring diagram:
http://i119.photobucket.com/albums/o141/Jay-gon_Jinn/MR%20Sound%20Board%20Pictures/101_5187-1.jpg
(That's what this topic is for, guys! ;))
Lord Maul
07-28-2010, 06:29 PM
Thanks to Shadar Al'Niende for this diagram of the Asajj Ventress FX
http://i187.photobucket.com/albums/x116/TaiDashan/Agony/Ventress/08WiringDiagShotLabeled.jpg
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.