Need help wiring mr fx construction kit soundboard

[airsoftmode]

Is it possible to wire a master replicas construction kit soundboard to power a 3w lux or p4 seoul? Anyone have a link to a wiring diagram. Thanks any help would be greatly appreciated.

[deathblood2]

yeah, check out here http://forums.thecustomsabershop.com/showthread.php?t=4091

might want a driver so you don't blow something up :D

[Novastar]

This is the thread you probably want:

http://forums.thecustomsabershop.com/forumdisplay.php?f=15

[airsoftmode]

Well thanks for the links, but those are for standard mr fx boards. I have a construction kit mr fx board, the kind that runs the three color led in the construction kit sabers. Anyone know of a way to wire them to run a k2 lux III or seoul p4?

[gundamaniac]

Try this:
http://forums.thecustomsabershop.com/showpost.php?p=77582&postcount=3

I'm also looking to use a 616 board without having to use pucks...this looks like the best bet and the route I'm probably going to take.

[Anavrin]

Try this:
http://forums.thecustomsabershop.com/showpost.php?p=77582&postcount=3

I'm also looking to use a 616 board without having to use pucks...this looks like the best bet and the route I'm probably going to take.

Yeah, I was hoping to use a six-wire buck puck (or two) to run all three LED's at once with a new power-pack, but don't know if the LED wires on the board would actually successfully mate with the CTL wires on the BuckPuck or not, and no one's replied XD So, it looks like I'm gonna try it and risk all of my electronics for this hilt at once!

I just wish this thing could take a momentary cause I've got the BEST switch for a US2.0 planned out...